TECHNICAL DATA ATO
-
43
AUTOMOTIVE
AIRCRAFT REMOVER
Form: GDH-33
Rev.: 040813
.DESCRIPTION AND USES
Rust-Oleum
®
Aircraft Remover is a fast acting remover
that strips finishes from metal automotive surfaces. Use
Aircraft Remover to quickly remove acrylics, lacquers,
polyurethane and baked enamels from automobiles and
trucks in 10 minutes which leaves a bare surface that is
ready to be primed or painted. Not recommended for use
on fiberglass, plastics, or any other synthetic surface. This
product is non-corrosive to all common metals under
normal exposure time
.PRODUCTS .
SKU Description
255447 1-Gallon Aircraft Remover
248874 1-Gallon Aircraft Remover
255448 1-Quart Aircraft Remover
248873 1-Quart Aircraft Remover
PRODUCT APPLICATION .
SURFACE PREPARATION
Remove or protect any portions of the vehicle not being
stripped. Mask seams and trim openings as this will
prevent bleed-back stripping of new finish. Spread a
solvent resistant drop cloth covered in newspaper around
work area in case of drips or spills. . Protect hands with
solvent-resistant gloves and eyes with chemical splash
goggles.
WARNING: If you scrape, sand, or remove old paint, you
may release lead dust. LEAD IS TOXIC. EXPOSURE TO
LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS
BRAIN DAMAGE, ESPECIALLY IN CHILDREN.
PREGNANT WOMEN SHOULD ALSO AVOID
EXPOSURE. Wear a NIOSH-approved respirator to
control lead exposure. Clean up carefully with a HEPA
vacuum and a wet mop. Before you start, find out how to
protect yourself and your family by contacting the National
Lead Information Hotline at 1-800-424-LEAD or log on to
www.eps.gov/lead.
PRODUCT APPLICATION (cont.) .
APPLICATION
Use outdoors or in a well-ventilated area such as an open
garage. Apply when temperature is between 65-90°F (18-
32°C). Pour remover into a metal or glass container and
apply a thick coat with a chemical resistant brush. If
applying to a vertical surface, begin the application at the
bottom, as vapors are heavier than air and can
accumulate near the floor. Apply to one section at a time
up to 9 square inches. Brush in one direction only. Allow
the remover to work until the finish is blistered or softened
completely, generally within 5-15 minutes. Remove paint
with a flexible plastic scraper and then flush with solvent or
water to remove any residue. Allow surface to dry before
applying a new finish. The metal should be primed as
soon as possible to prevent flash rust.
NOTE: This product may not be compatible with all
surfaces and all conditions surrounding the application.
Before applying to any surface, always test product in a
small inconspicuous area to ensure no damage will result.
This product is not recommended for use on fiberglass,
plastics or any other synthetic surface.
CLEAN UP
Tools and brushes should be cleaned with soap and water
immediately after use.
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals