TECHNICAL DATA ATO-13
AUTOMOTIVE
LENS TINT
Form: GDH-427
Rev.: 081114
.DESCRIPTION AND USES .
Rust-Oleum
®
Lens Tint is a translucent coating that is designed
to give your vehicle a customized appearance. When applied,
Lens Tint gives your lights a tinted appearance until they are lit.
When illuminated the natural color shows through. Lens tint is
ideal for tail lights, fog lights, side markers, or turn indicators and
is recommended for off road use. Rust-Oleum Lens Tint features
an advanced spray system that allows you to spray at any angle,
even upside down for those hard to reach areas. A comfort spray
tip with a wider finger pad reduces fatigue caused by continuous
spraying.
.PRODUCTS .
SKU Description
253256 Transluscent Black
260860 Silvercast
..PAINTING APPLICATION .
PAINTING CONDITIONS
Use outdoors or in a well ventilated area such as an open
garage. Use when temperature is between 50°F (10°C)
and 90°F (32°C) and humidity is below 85% to ensure
proper drying. Do not apply to surfaces, when heated,
exceed 200°F (93°C). Avoid spraying in very windy and
dusty conditions. Cover surrounding area to protect from
spray mist.
SURFACE PREPARATION
Removing the lens from your vehicle is recommended for
ease of application. If you cannot remove the lens from
your vehicle, mask adjoining areas to protect from spray
mist. Prepare the surface by removing any oil, grease,
wax, or road tar. For best results use a clean cloth and
wipe the surface with Rust-Oleum
®
Wax & Tar Remover.
..PRODUCT APPLICATION (cont.) .
APPLICATION
Shake can vigorously for one minute after the mixing ball
begins to rattle. If mixing ball fails to rattle DO NOT
STRIKE CAN. Contact Rust-Oleum. Shake often during
use. Hold can upright 10-16" from surface and spray in a
steady back-and-forth motion, slightly overlapping each
stroke. Keep the can in motion while spraying. Apply one
light coat or just enough to change the lens color. DO NOT
exceed three coats or light may not show through. Do not
use near open flame.
DRY & RECOAT
Dry and recoat times are based on 70°F and 50% relative
humidity. Allow more time at cooler temperatures. Dries to
touch in 20 minutes, to handle in 1 hour and is fully dry in
24 hours. Apply a second coat within 1 hour or after 24
hours.
CLEAN-UP
Wipe off tip when finished. Clean-up wet paint with xylene
or mineral spirits. Properly discard empty container. Do
not burn or place in home trash compactor.
CLOGGING
If the valve clogs, twist and pull off spray tip and rinse in a
solvent such as mineral spirits. Do not insert any object
into can valve opening.
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals